Purpose:
To
examine the influence of pressure differences
Equipment:
clean
and empty aluminum cans (soda cans with ridges at the ends work best),
hot plate, shallow dish or pan, safety equipment (heat resistant gloves;
tongs, goggles also recommended)
Procedure:
Fill the dish or pan about half full with water.
Put ~15mL of water into a can (just enough to cover the bottom). Place the can on the hot plate and turn on the hot plate. Heat the can and water until the water is boiling. This will likely take just a couple of minutes. Steam will come out of the hole in the top of the can when the water is boiling. Let the can steam for at least another minute to try to maximize the ratio of water vapor to dry air inside the can.
As rapidly and carefully as possible remove the can from the hot plate, turn it upside down, and submerge the top of the can in the water. The faster this is done, the better. It is recommended to have the pan of water near the hot plate so you may grab the can about in the middle with the hand turned over (thumb pointing down) and in one motion turn it over and into the water.
With a little luck and skill the can will be crushed and water will be drawn up into the can.
Also, since the air pressure pushing down on the water outside of the can is much greater than the air pressure pushing down on the water through the drinking hole of the can, water is drawn up into the can.
To further convince
yourself the condensation of the water vapor is what leads to the rapid
fall of pressure inside the can, try the same procedure without putting
any water into the can. As long as the can is dry, some water will
likely be drawn into the can, but it will not be crushed. However,
do remember this is an extreme demonstration and that evaporation and condensation
have only a small effect on air pressure in the atmosphere.
2) Pressure imbalances
exert a net force on objects.